Dear Realsense team,
I and my team have been using the L515 depth camera in our robotics system for about a year and a half. Now we are getting wrong depth values returned from the camera. I have already updated firmware in the Realsense viewer and reset the hardware, unfortunately without success.
It seems to me that the camera has developed an offset of about + 5-6 cm in Z - Direction. Has this problem occurred before, or could it have something to do with the lifespan or wear of the camera ?
We also tried different presets (short range, ...) and looked into camera temps. Temps were a bit high at some point, with values around 50 degrees, but the problems also occur with temps around ~30 - 40 degrees.
Please sign in to leave a comment.