
MartyG
- Total activity 1812
- Last activity
- Member since
- Following 0 users
- Followed by 1 user
- Votes 0
- Subscriptions 567
Activity overview
Latest activity by MartyG-
MartyG commented,
If you require dust and water protection and would prefer to use the D455 camera model, the company autoVimation offer a protective enclosure for the D455 model that has IP66 and IP67 protection (b...
-
MartyG commented,
In Mode 3 (Full Slave) it will behave like Mode 2. So it will stream continuously instead of waiting for a trigger. It is Genlock mode 4 and above that waits for a trigger, and those modes only s...
-
MartyG commented,
You are very welcome! You are correct about Mode 2, it will still stream in the configured FPS whether sync is active or not. In regard to your further questions: 2. RGB is not synced in gen...
-
MartyG commented,
Mode 2 listens on every frame, so it would be the same period of time no matter which FPS rate is set. AS far as I am aware, the precise wait period on each frame has not been defined. The origi...
-
MartyG commented,
The camera will generate depth data for whatever areas of the scene that the cameras can see in the FOV and analyze for depth. If part of the FOV is obscured then this does not prevent the generat...
-
MartyG commented,
Hi Yxliuwm The stereo baseline is the distance between the center-lines of the left and right sensors. As these physical sensor positions are fixed, the baseline cannot be changed.
-
MartyG commented,
Hi Roman Leuzinger The field of view (FOV) of the camera module's sensors should not be obscured by any non-transparent part of the custom housing that is on the front of the housing. If you are...
-
MartyG commented,
HI Yxliuwm If you wish to illuminate the scene with infrared light but do not need the dot pattern, the best solution for you may be to change the value of the Laser Power setting. This affects t...
-
MartyG commented,
The RealSense Viewer has a range of post-processing filters enabled by default. So you could test your theory by left-clicking on the blue icon beside Post-processing in the Viewer's options side-p...
-
MartyG commented,
Hi Fpelegri. Unplugging the camera from the USB port will close any currently open pipeline. When the camera is re-inserted into the USB port, the default configuration of the particular camera mo...